Beer Line Cleaning Kit

How to Use Tap Tech

How to Use Tap Tech’s Beer Line Cleaning Kit: A Step-by-Step Guide

Keeping your lines clean is critical to maintaining the quality and taste of your beer. However, the process can be tedious and time-consuming without the right tools. That’s why Tap Tech offers an innovative self-service kit that simplifies the process and ensures your beer lines remain spotless. In this step-by-step guide, we’ll walk you through how to effectively use Tap Tech’s kit to keep your system running smoothly and your beer tasting fresh.

Step 1: Set Up the Cleaning Keg

The first step in cleaning your beer lines is preparing the cleaning keg. Our kit is designed to clean 2 lines at once, using our no-rinse solution – Here’s how to get started:

  1. Fill the stainless steel cleaning keg with warm water.
  2. Add the recommended amount of Tap Tech’s no-rinse cleaning powder into the keg. Stir gently to dissolve the powder.
  3. Attach the cleaning keg to the beer line couplers. Tap Tech’s keg is compatible with standard D-type couplers.

Step 2: Connect the Cleaning Keg to Beer Lines

Once your solution is ready, it’s time to connect the cleaning keg to the beer lines:

  1. Disconnect the regular beer keg from the beer lines.
  2. Attach the cleaning keg to the same couplers you just disconnected from the beer keg.
  3. Place included the bucket under the beer tap to catch the solution.
  4. Open the beer taps to start pushing the solution through the lines.
  5. Allow the cleaning solution to circulate through and/or sit in the lines for 2-15 minutes.

Step 3: Rinse and Flush the Beer Lines

Although Tap Tech’s solution requires no rinsing, you should still give your lines a final water rinse to clear out any remaining residue:

  1. After the cleaning cycle, disconnect the cleaning keg from the couplers and refill with warm water.
  2. Reconnect the cleaning keg.
  3. Open the taps again to push the water through the lines, flushing out any remaining solution.

Step 4: Reconnect Your Beer Kegs

Clean and flush your lines, then reconnect your beer kegs to get started.

  1. Reattach the beer kegs to their respective couplers.
  2. Open the beer taps to pour the first bit of beer through, discarding the initial pour as it may contain water.
  3. Your lines are now clean, and you’re ready to start serving great-tasting beer again!
  4. Repeat the process for each tap every 2 weeks.

Conclusion

With Tap Tech’s kit, maintaining clean beer lines has never been easier. Our no-rinse cleaning solution saves time and effort, allowing you to focus on serving the best quality beer. Be sure to clean your lines regularly to ensure consistent taste and quality. Ready to simplify your process? Check out Tap Tech’s products and get started today by exploring our shop today! https://thetaptech.com/tap-line-cleaning-kit/